Tablet wp8060u driver for mac5/24/2023 ![]() However, they're not just used for making fancy geometric shapes, as it's usually much cheaper for a large factory's R&D department to print a single model in plastic rather than rigging up the whole factory to make the actual part. This is called prototyping, making a rough draft to help test the final copy without wasting valuable time and materials. ![]() ![]() Since a printer doesn't understand how to take a complex 3D mesh and turn it into a printed model, the 3D model must be decoded into information that the printer can understand. This process is called slicing since it takes scans of each layer of the model and tells the printer how it should move the print head to create each layer in turn. It's done with the aid of a slicer, a program that handles all of this for you, like CraftWare or Astroprint. The slicer will handle the "fill" of the model, creating a lattice structure inside a solid model to give it extra stability. This is one area where 3D printers shine-they can print very strong materials with really low densities, by strategically creating pockets of air inside the model and making it much lighter.Īnother thing the slicer handles is support columns. Since the printer can't lay down plastic on thin air, support columns must be created to allow the printer to bridge the gap. These are removable but are used in the printing process to ensure it doesn't collapse.
0 Comments
Leave a Reply. |