Case tl100 trencher manual5/25/2023 ![]() ![]() I would appreciate and consider ANY and all input. What online sources are you guys finding good deals and good selection on? I have seen what tractor supply stocks for sprockets/gears/hydraulic cylinders/pto driveshafts and parts/etc and feel like I could get 90% of what I need from there. Fabricating hydraulic controls into it may turn it into more of a project than I would like to make out of it, although it is an option and I could tap into the FEL controller to operate it but it would be even better with secondary controls. I think I would have to use a gearbox and I have a small brushhog and also a belly mower to scavenge parts (Gearboxes) from if need be.Īny suggestions? I plan on using a combination of the hand crank and the 3 point lift arms to set digging depth. Ive got to get PTO power to the trencher and turn the power output 90 degrees to interface with the rest of the pulley system. Everything is done via belts/pulleys/chains and the digging arm goes up & down via a hand crank. The old trencher is completely non-hydraulic. SO I have decided to get rid of the engine, transaxle, and adapt it to receive some 3 point arms and a PTO drive so I can run it behind my BX2200. The engine is very old and tired, but the digging arm and chain/teeth are in good useable condition. ![]() Ive got an old Case TL-100 walk behind trencher that broke a gear inside the transaxle so its basically junk.
0 Comments
Leave a Reply. |